1 2 3 4 5
6 replies

New Cura 2.1 open beta released.

Created by: 3DForms | Views: 1165 | Last reply July 4, 2017 by 3DForms
2 replies

Recent Cura settings optimized for Craftbot

Created by: mapoisson | Views: 298 | Last reply July 4, 2017 by Luke
4 replies

Simplify3D as host

Created by: Bart ter Haar | Views: 176 | Last reply June 1, 2017 by Bart ter Haar
0 replies

More info on stringing

Created by: Birk Binnard | Views: 114 | Last post May 31, 2017 by Birk Binnard
4 replies

How to prevent stringing

Created by: Birk Binnard | Views: 192 | Last reply May 23, 2017 by Birk Binnard
3 replies

3D Builder is improved

Created by: Birk Binnard | Views: 985 | Last reply May 15, 2017 by Birk Binnard
7 replies

Slicer Speed Test

Created by: Birk Binnard | Views: 208 | Last reply April 27, 2017 by Birk Binnard
0 replies

Variable Layer Heights

Created by: Birk Binnard | Views: 223 | Last post April 19, 2017 by Birk Binnard
5 replies

Craftware/Plic3r speed comparison

Created by: Birk Binnard | Views: 327 | Last reply April 17, 2017 by Birk Binnard
6 replies

Parametric Modeling

Created by: Birk Binnard | Views: 459 | Last reply April 4, 2017 by WestReak
9 replies

MatterControl

Created by: BV | Views: 399 | Last reply April 3, 2017 by BV
5 replies

UH oh - I did it again

Created by: Birk Binnard | Views: 507 | Last reply February 8, 2017 by Birk Binnard
4 replies

Simplify3D Issue

Created by: Jeremy Littler | Views: 845 | Last reply December 9, 2016 by Jeremy Littler
1 2 3 4 5
To start a discussion or reply to a post please Login or Create an account.